computing error

英 [kəmˈpjuːtɪŋ ˈerə(r)]

美 [kəmˈpjuːtɪŋ ˈerər]

网络  计算误差; 运算差; 运算误差

计算机

双语例句

• Discussed a means to deal with dimensional chain computing with symmetry error in two way: computing analysis and geometry analysis.
  从计算和几何分析两条途径，讨论尺寸链计算中对称度误差的处理方法，为类似计算提供参考意见。
• Study on Computing Error of Transient Temperature Field Based on Finite Difference Method
  基于有限差分法的瞬态温度场计算误差研究
• A DNA Computing Method for Error Permutation Problems
  错排问题的DNA计算方法
• Tested values of mechanical error, physical error, graduation factor and quantizing error were input into compensation module, then made the two-position seeking north computing and error compensation of rotate angle.
  将陀螺和加速度计的机械误差、物理量误差、标度因数及量化误差等测量值输入补偿模块，进行二位置寻北解算和转角误差补偿。
• The formulas of computing local filter error variances and cross-covariance are given, which are applied to compute optimal weighting coefficients.
  给出了计算局部滤波器误差方差和互协方差的公式，它们可被用于计算最优加权系数。
• Through adjusting weight, computing error rate and modifying the parameters of hidden nodes, optimal results will be achieved in the learning procedure.
  学习过程通过调整权值、计算误差、修正隐层单元的参数，以达到最优结果。
• A Theoretic Method on Computing Mismatch Error of the Measure Result Obtained Under the Solar Simulator With Spectrum Mismatch
  太阳模拟器中的光谱失配误差的研究
• The computing error of turbulent flow shear rate is less than that of energy dissipation. PERCOLATING RULE OF THE NON NEWTONIAN POWER LAW FLUID IN THE HORIZONTAL WELL OF FRACTAL RESERVOIRS
  参照牛顿流体能量耗散率的计算方法，提出了幂律流体管内湍流能量耗散率的近似算法。分形油藏中水平井的非牛顿幂律流渗流规律
• Although the tread irregularities depth computing result error is a little big due to the sampling frequency is too low. We believe that the tread irregularities depth computing result will improve with enhancing the frequency of the sampling.
  擦伤精度虽由于采样频率太低的原因而误差稍大，但趋势明显，相信只要提高频率，擦伤深度的测量精度会改善。
• The paper establishes counting model of its, which makes spacial programme turn into plane programme. The method reduces computing error and increases calculating veracity, improves precision of processing screw.
  它使空间编程问题归结到平面上，减少模型造成的计算误差，提高了刀位点计算准确性，大大改善螺杆数控加工的精度；